Engine Dynamometer -Waterbrake- Earthmoving, locomotives & powerful diesel engines

Hyper power supply a wide range of engine dynamometers to accommodate all types of engine performance requirements. Where Eddy current brake units are used, cooling towers, piping, special liquid additives and frequent maintenance are not unnecessary. These engine dyno’s are thus very affordable and easy to install while maintenance is inexpensive, compared to water brake units. 

Dynamometer Control Unit - Retarder Unit

• Power requirement : 220 V 25
• Speed stability : ±5 rpm
• Load stability : ±0,1 kW
• Temperature sensor accuracy : 0,5 %
• Pressure sensor accuracy : 0,5 %

Dynamometer Control Unit - Waterbrake Unit

• Power requirement : 220 V 1A
• Air supply - regulated : 5 Bar
• Speed stability : ±5 rpm
• Load stability : ±0,1 %
• Temperature sensor accuracy : 0,5 %
• Pressure sensor accuracy : 0,5 %

Options:

Sensors:

• Up to 64 analogue input channels (eg Pressure, Temp. ect) can be logged for later processing.

Engine stand:

• Universal Engin stand with 3 dimensional thread rod type adjustments on rubber mountings.

Cooling fan for retarder:

• 380V 5.5 kW fan ensures prolonged testing at constant speeds.

Lambda Sensor:

• Integrated wide range oxygen sensor to give Air/Fuel ratio readings on graph.